|
KMID : 1033720220230040178
|
|
Archives of Craniofacial Surgery
2022 Volume.23 No. 4 p.178 ~ p.182
|
|
|
Cranioplasty and temporal hollowing correction with a three-dimensional printed bioresorbable mesh and double vertical suture anchor muscle sling: a case report
|
|
Choi Jae-Hyeok
Roh Tai-Suk
Lee Won-Jai
Baek Woo-Yeol
|
|
|
Abstract
|
|
|
|
Postoperative temporal hollowing is a common complication of craniotomy. Damage and repositioning of the temporalis muscle can lead to a depression in the temporal side of the skull with inferior bulging, worsening aesthetic outcomes. We report a case of cranioplasty with three-dimensional (3D) printed mesh involving an additional correction using a temporalis muscle sling to help address this problem. A 3D-printed bioabsorbable mesh was prepared based on preoperative facial computed tomography, and was fixed to the hollowed area for tissue augmentation. The temporalis muscle was elevated and fanned out to its original position, and a sling was attached to a screw that was fixed to the mesh. For reinforcement, an additional sling was attached to another screw fixed to the mesh 2?3 cm vertically above the first screw. Aesthetic results were confirmed immediately after surgery and later during outpatient follow-up. Both depression and lateral bulging were resolved, and there was no delayed drooping of the temporalis muscle on 6-month follow-up. There were no complications, and the patient was satisfied with the appearance. This is a simple yet effective technique with a low risk of complications, and should be considered for postoperative temporal hollowing patients, especially those with severe lateral bulging.
|
|
|
KEYWORD
|
|
|
Case reports, Reconstructive surgical procedures, Surgical mesh, Temporalis muscle
|
|
|
FullTexts / Linksout information
|
|
|
|
|
|
Listed journal information
|
|
  
|