The purpose of the present study is to evaluate the stress distribution on the length and diameter of the miniscrew and cortical bone width. Three dimensional finite element models were made of diameter 1.2mm, 1.6mm, 2.0mm and length 6.0mm, 8.0mm, 10.0mm, 12.0mm and cortical bone width 1.0mm. Also, another three dimensional finite element models were made of diameter 1.2mm, 1.6mm, 2.0mm and length 8.Omm and cortical bone width 1.0mm, 1.5mm, 2.0mm, 2.5mm. Two-hundred grams horizontal force were applied on the center of the miniscrew head and at that stress distribution and its magnitude had been analyzed by ANSYS, which is three dimensional finite element analysis program.
The obtained results were as follows
I. The comparison of the maximum von-Mises stress in the miniscrew showed that as the diameter increases from 1.2mm to 2.0mm stress has been decreased, while on the same diameter stress was not changed regardless of the length change.
2. The comparison of the maximum von-Mises stress in thee cortical and cancellous bone showed that as the diameter increases from 1.2mm to 2,0mm stress has been decreased, while on the same diameter stress was not changed regardless of the length change.
3. In the analysis of the stress distribution in the cortical and cancellous bone, the most of the stress had been
absorbed in the cortical bone, and did not transmitted much to the cancellous bone.
4. In the analysis of the maximum von-Mises stress according to the cortical bone width, the same diameter of
the miniscrew showed a constant stress value regardless of the cortical bone width change.
The above results suggest that the maintenance of the miniscrew is more reliable on diameter than length of the miniscrew.
|